Universal fit 100 litre water tank with backfill system suitable for Motocross, Racevans, Valeting or Jetwashing or Window Cleaning. The autocraft water tank backfill system allows you to quickly, and easily, fill the water tank using a standard hozelock. It also doubles up as an outlet, meaning that you can use it as a jet wash tank (Your jet wash must be able to draw water from the tank to use this system) The backfill system can also be used to drain the tank, removing the need to fit a drain tap.
1x 100 Litre Polyethylene Water Tank (Height = 350mm / Width = 400mm / Length = 750mm). 1x Aluminium Bracket (suitable for trimming down to fit different vans and mounting locations). 1x 15mm to 3/4 BSP heavy duty hand valve (used to turn on and off water flow). Adapter used to connect to 1/2? Water pipe coming from tank.Benefits of the Autocraft water tank backfill system. We have used this product on our own conversions and have not yet found a vehicle that it is not compatible with. The bracket is a universal fitting which means it can be placed anywhere suitable on your van, and you can avoid cutting a hole in the side of your van.
This system can be fitted to new conversions or retrofitted to existing conversions. To assemble the backfill system, the 15mm to 1/2? Adapter has a push-fit fitting which simply clicks into the heavy duty hand valve. On the other end of the heavy duty hand valve is a threaded 3/4?BSP fitting, the aluminium bracket is placed on this end and then the hozelock is screwed on tight (over the thread of the tap) to complete the kit. You can screw the hozelock on to the tap by hand but it needs to be as tight as possible, we recommend using pliers to ensure a secure and perfect seal.
To fit the water tank fittings you will need to drill holes in the desired locations of the tank, place the threaded fitting into the hole (with the seal on the outside of the tank where any seals are supplied) and then affix and tighten the bolt on the thread using the tank's access hatch to reach the inside. The breather inlet should be placed as high as possible on the tank. The water feed outlet, for water going into the van, should be placed as close to the bottom of the tank as possible. The water inlet should also be placed close to the bottom of the tank so that it can also be used to drain the tank.
When attaching the pipe to the water tank fittings we recommend putting the pipe into hot water first to increase its flexibility. In order to fit the tank we recommend using our Universal Water Tank Mounting Strap Kit. Please see our other listings for the Mounting kit.
This item is in the category "Business, Office & Industrial\Agriculture/Farming\Storage Tanks". The seller is "autocraftmc" and is located in this country: GB.